Describe it.
Build it.
Tell 10 Benches the device you want — in plain words — and get a complete, buildable hardware project back: working Arduino code, a parts list, a wiring diagram, a parametric enclosure CAD file, a step-by-step guide — and a simulator so you can watch it behave before you build it.
Free tier: 25 credits every month, resetting on the 1st. No card, no per-token charges, ever.
Hallway Motion Light
Motion-Activated Light block · Arduino Uno · no extra libraries
const int PIR_PIN = 2;
const int OUT_PIN = 8;
const unsigned long HOLD_MS = 30000UL;
void loop() {
if (digitalRead(PIR_PIN) == HIGH) {
lastMotion = millis();
if (!lightOn) {
digitalWrite(OUT_PIN, HIGH);
lightOn = true;
}
}
// …full sketch in the builder
}
Built from one sentence
This is a real 10 Benches output — the exact project the prompt above generates, not a mockup. Parts, wiring, and code, ready to build.
Hallway Motion Light — what you need
| Part | Qty |
|---|---|
| Arduino Uno R3 (or compatible) | 1 |
| PIR motion sensor module (HC-SR501) | 1 |
| LED, 5mm (any color) | 1 |
| Resistor, 220 ohm | 1 |
| Solderless breadboard, 400-point | 1 |
| Jumper wires (male-to-male, assorted) | 1 pack |
| USB cable (A to B) | 1 |
How it wires up
| From | To |
|---|---|
| PIR sensor OUT | Arduino D2 |
| PIR sensor VCC / GND | Arduino 5V / GND |
| Arduino D8 | 220 ohm resistor, then LED long leg (+) |
| LED short leg (-) | Arduino GND |
The sketch you download
/*
* Hallway Motion Light
* Generated by 10 Benches (10benches.com)
* Board: Arduino Uno R3
*/
const int PIR_PIN = 2;
const int OUT_PIN = 8;
const unsigned long HOLD_MS = 30000UL; // 30 seconds
unsigned long lastMotion = 0;
bool lightOn = false;
void setup() {
Serial.begin(9600);
pinMode(PIR_PIN, INPUT);
pinMode(OUT_PIN, OUTPUT);
digitalWrite(OUT_PIN, LOW);
}
void loop() {
if (digitalRead(PIR_PIN) == HIGH) {
lastMotion = millis();
if (!lightOn) {
digitalWrite(OUT_PIN, HIGH);
lightOn = true;
Serial.println("Motion - light ON");
}
}
if (lightOn && (millis() - lastMotion > HOLD_MS)) {
digitalWrite(OUT_PIN, LOW);
lightOn = false;
Serial.println("Quiet - light OFF");
}
}
One promise, one simple model
A monthly pool of credits that resets on the 1st — an allowance, not a bucket that runs dry. A generation is 5 credits; each export is 1. No per-token charges, no surprise meters.
Enough to build a project a week and take the files home. Resets monthly, forever free.
Start freeFor a hobby bench that never sits idle — a new build every weekend, exports included.
Start freeFor classrooms, clubs, and serious makers running several projects at once.
Start freeFor prototyping shops that build daily and export everything, every time.
Start freePaid plans launch soon — the Free tier is live now, and checkout will never ask for card details anywhere but a real payment page.